Everlast Hatchet 60 Plasma Cutter

The Everlast Hatchet 60 is a no-nonsense, compact and lightweight plasma cutter built for hand cutting in small shops, home garages and on the farm. It runs off mains power or a clean power generator for work out in the field.

Features

• Blowback pilot arc for fast, reliable starts and easy cutting of rusty, dirty and painted metal
• Cuts virtually any type of metal
• Genuine IPT-60 torch for clean, smooth cuts, with inexpensive service parts and consumables
• Light commercial class, 35% duty cycle at 60A
• Auto pilot arc restart and auto post flow
• Front-mounted pressure gauge
• Suitable for 10,000W surge "clean power" generators (5% or less THD)

Specifications

• Type: IGBT inverter
• Input: dual voltage 120/240V, single phase
• Output range: 120V: 20–30A / 88–92V; 240V: 20–60A / 88–104V
• OCV: 300V
• Max inrush current (I1max): 120V: 36A; 240V: 41A
• Maximum rated input current (I1eff): 120V: 22A; 240V: 25A
• Duty cycle (40°C): 120V: 35% @ 30A, 25A @ 60%, 20A @ 100%; 240V: 35% @ 60A, 50A @ 60%, 40A @ 100%
• Arc start: blowback (piston type), pilot arc
• Torch: IPT-60 (Innotec)
• CNC interface port: no
• Adjustable post flow timer: no
• Gouging: not recommended
• Cutting air pressure: approx. 4.5–5.0 bar (65–72 PSI)
• Recommended compressor: 5.3 CFH @ 90 PSI with 20–30 gallon (approx. 75–115L) reserve
• OK-to-cut indicator and low air pressure safety: yes

Cutting Capacity

• Up to 14mm (9/16") daily use @ 15–20 ipm
• Up to 22mm (7/8") clean cut @ 8–12 ipm
• Up to 25mm+ (1"+) severance cut @ 3–5 ipm
• Pierce up to 12mm (1/2")

Cutting capacity depends on dry air, new consumables and correct air pressure; cut quality depends on consumable orifice size, standoff height and travel speed.

What's Included

• IPT-60 handheld torch, 4.3m (14ft), with Euro quick-connect central connector
• Ground clamp with 25 DINSE connector
• Air pressure regulator/water trap (a separate air dryer is required to reduce consumable wear and prevent torch damage)
• Consumable starter kit
• WEiPU SP21 CNC connector, 12 pin

Notes

• Not for use with CNC table systems; CNC use will void the warranty.
• Generator use: the generator must be rated at 5% or less THD and at least 10,000W surge. Using a generator that is not clean power, even if it meets the wattage, will void the warranty.
• To get full performance and duty cycle, make sure your breaker, wiring and socket are up to the job; you may need a 32A dedicated circuit. If in doubt, talk to a licensed electrician before purchasing and see our terms and conditions/warranty.
• Manufactured to and compliant with IEC/AS 60974.10 and CE. Industrial use only.

Download the PDF manual | Download the PDF brochure